Tips And Recommendations For Installation - SOMFY HOME MOTION Tilt 50 RTS Notice

2.4. TiPS aNd rECOmmENdaTiONS fOr iNSTallaTiON

2.4.1. questions about the Tilt 50 rTS?
Observations
There may be some radio
interferences.
The motorised
product does not
One or more batteries have been
operate.
mounted backwards.
Batteries (inside battery tube) are
weak.
The control point battery is weak.
The control point is not
compatible.
The control point used has not
been programmed into the motor.
2.4.2. re-setting the end limits
readjusting the upper end limit
1) Press the up button to bring the motorised product to the end limit to be readjusted.
2) Press the up and down buttons at the same time until the motorised product moves
up and down.
3) Press the up or down button to move the motorised product to the new desired
position.
4) To confirm the new end limit, press the my button until the motorised product moves
up and down.
readjusting the lower end limit
1) Press the down button to bring the motorised product to the end limit to be
readjusted.
2) Press the up and down buttons at the same time until the motorised product moves
up and down.
3) Press the up or down button to move the motorised product to the new desired
position.
4) To confirm the new end limit, press the my button until the motorised product moves
up and down.
8
Possible causes
Copyright © 2015 Somfy SAS. All rights reserved - V1 - 03/2015
Solutions
Unplug the motor supply cable
and reconnect the battery tube to
the motor.
Verify that batteries are all
mounted in the correct manner.
Check whether the batteries are
weak and replace if necessary.
Check whether the battery is
weak and replace it if necessary.
Check for compatibility and
replace the control point if
necessary.
Use a programmed control point
or program this control point.