Parker PSD1 Manuel D'installation page 24

Introduction
Mains module Manufacturer
ABB
Frankreich
PSD1-M_P01
(E322885)
0
Cooper Bussmann LLC
PSD1-M_P02
(E340782)
0
DEHN + SOEHNE GmbH
+ Co. KG. (E319777)
Risk of Electric Shock, wait at least 10 minutes before removing cover.
Connecting protective earth
Connect protective earth via a copper wire of minimum
10 mm
of the PSD1M (axis controller) and of the mains module
PSD1-M_P:
24 (126)
Conditions of utilization for CSA certification
2.10.4.4
External Overvoltage Protection
External overvoltage protection in accordance with Canadian Standards
C22.2-No.274-13 with over-voltage protection device (VZCA2) CSA-certified.
Note the following table:
Model No
(Quantity 1)
OVR T2 3N
40-440 P(TS)U
BSPM 4480 WY NGR
904 346
Ground rail not sufficient
For CSA approval, earth rail must be replaced by a direct earth connection.
Removing the earth rail (4) (Right):
1 24 VDC
2 GND 24 VDC
3 DC power supply bus -
4 Protective earth
5 DC power supply bus +
by means of the provided screws at the bottom
2
193-011006N8 2019-11
Maximum Voltage
Continuous Protection
Operating Rating
Voltage (Vac) (VPR)(Vpk)
L-GND L-GND
420 Veff Max 1500 V Max
L-L L-L
840 Veff Max 3000 V Max
L-GND L-GND
660 Veff Max 2500 V Max
L-L L-L
770 Veff Max 2500 V Max
25.11.19 14:26
Category
/
Nominal earth
leakage current
1
/
10 kA
1
/
20 kA