Comet VR 10 Notice Technique page 17

GCP 3v
hPR
hPR 2
vR 20
vR 40
Alfa
Orion
GRv 2v/4v
vRS
The Manufacturer reserves the right to make any changes to the appliance which are deemed suitable.
Refer to figures 1, 2 and 3 at the beginning of this use and instruction manual.
1. Inlet connection
2. Tap
3. Delivery connection
4. By-pass connection
The identification plate (6) shows the main technical features of the control unit: model, max. flow rate, max.
pressure.
The identification plate is placed: on the casing of the GCP 3V, HPR, VR 20, VR 40, ALFA, ORION and VRS
control units; on the by-pass/pressure lever of the VR 10, Centralina 4V/6V and Hydra control units; on the
pressure gauge of the VR 15, Gemini, Sirius, Polaris, HPR 2 and GRV 2V/4V control units.
CAUTION
• If the identification plate should be damaged during use, contact your authorised dealer or service centre to
get it restored.
CAUTION
• The control unit is exclusively intended for the following uses:
- protection treatments of agricultural and gardening crops;
- pumping of detergents and colours in water solution (not inflammable);
- pumping water not intended for human consumption.
• The control unit is the necessary complement of the pump incorporated in the machine on which it is installed.
The restrictions of use provided for the pump in the use and maintenance manual also apply to this
control unit; these use restrictions are fully reported in this document.
Any different use should be considered improper.
The Manufacturer cannot be held liable for damages arising from an improper or incorrect use.
PERFORMANCE
MAXIMUM FLOW RATE
100 l/min - 26,4 US gpm
150 l/min - 39,7 US gpm
150 l/min - 39,7 US gpm
100 l/min - 26,4 US gpm
100 l/min - 26,4 US gpm
180 l/min - 47,6 US gpm
180 l/min - 47,6 US gpm
240 l/min - 63,4 US gpm
240 l/min - 63,4 US gpm
These technical features and data are given as an indication only.
IDENTIFICATION OF COMPONENTS
5. Pressure gauge
6. Identification plate
7. Pressure regulation wing nut
8. General closing lever
IDENTIFICATION PLATE
INTENDED USE
MAXIMUM PRESSURE
50 bar - 725 psi
50 bar - 725 psi
50 bar - 725 psi
20 bar - 290 psi
40 bar - 580 psi
50 bar - 725 psi
50 bar - 725 psi
50 bar - 725 psi
50 bar - 725 psi
9. By-pass/pressure lever
10. Tap lever
11. hook
12. Selecting lever
MASS
1,2 kg - 2,6 lb
2,6 kg - 5,7 lb
2,2 kg - 4,9 lb
1,0 kg - 2,2 lb
1,0 kg - 2,2 lb
2,9 kg - 6,4 lb
4,2 kg - 9,2 lb
3,2 kg - 7,0 lb
2,6 kg - 5,7 lb
GB
17