Table des Matières
Publicité
and water safety to environmental protection in force in the place of installation. So
for the hydraulic plant contact an authorized technician. Always utilise the new hose
supplied for connection to the water supply. Old hoses must not be utilised.
•
On installation, the qualified electrician must fit a circuit breaker switch as fore-
seen by the safety norms in force that has a contact open distance that permits the
complete disconnection under conditions of overload category III.
For Australia, the above must be done according to the AS / NZS 3000 installation
standard.
•
In case of installation in kitchens, connect the equipotential conductor to the ter-
minal on the machine indicated by the symbol .
•
There are some basic rules for the use of any electrical appliance. In particular:
•
Never touch the unit with wet hands or feet;
•
Never use the unit with bare feet;
•
Never use extension cords in areas equipped with baths or showers;
•
Never pull on the power supply cord to unplug the unit;
•
Never leave the unit exposed to atmospheric agents (rain, direct sunlight, etc..);
•
Never let children, unauthorized personnel or anyone who has not read this
manual operate the unit.
•
The qualified electrician must also check that the section of the installation's ca-
bles is large enough for the absorbed power of the appliance.
•
Never use adapters, multiple jacks or extension cords. When such items prove ab-
solutely necessary, call in a qualified electrician.
•
To prevent dangerous overheating, it is advisable to fully extend the power supply
cord. Never block the intake and/or heat dissipation grills, in particular those for
the cup warmer.
•
The user must never replace the unit's power supply cord. If this cord is damaged,
turn off the unit and have it replaced by a professionally qualified technician.
•
Should it be necessary to replace the power cord, this replacement operation must
only be performed by an authorized service centre or by the manufacturer.
•
The device needs to be supplied with water that is suitable for human consumption
and compliant with the regulations in force in the place of installation. The installa-
tion engineer needs confirmation from the owner/manager of the system that the
water complies with the requirements and standards stated above.
•
For machines connected to the mains water supply, the minimum pressure must
be 2 bar and the maximum pressure for correct machine operation must not ex-
ceed 4 bar.
12
•
The manufacturer cannot be held responsible for
any damages incurred if the system is not grounded.
For electrical safety, this machine requires a ground
system. Contact a technically certified electrician
who must check that the line electrical capacity is
adequate for the maximum capacity indicated on
the unit label.
Publicité
Table des Matières
