Table des Matières
Publicité
17
Technical Information
Connection C - Electrical
Connection C - Electrical
Figure 47
The turbopump is connected to the controller through an 8-pin connector. Pins
B, C and D are the 3-phase supply to the motor, pin E is connected to the
pump ground, pins G and H are not connected, pins A and F reserved for
Agilent.
If the temperature sensor is disconnected, the pump will not start. To prevent
damage to the pump when the temperature exceeds 60 °C, the sensor
automatically cuts out the power supply.
286/296
TV 1001 SEM User Manual / 87-900-973-01 (H)
Publicité
Chapitres
Table des Matières
