Signal Description - Agilent Technologies TV 1001 SEM Notice De Mode D'emploi

Tab. 4
PIN N.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15

Signal Description

Start/Stop: input signal to start or stop the pump. With the supplied cover
connector the START/STOP (+) signal is connected to the +24 Vdc pin and the
START/STOP (-) signal to the GROUND pin: in this condition the pump
automatically starts as soon as the controller recognises the input supply
("Plug & Pump").
Interlock: input signal to control the pump rotation. With the supplied cover
connector the interlock (+) signal is connected to the +24 Vdc pin and the
interlock (-) signal to the GROUND pin.
Speed setting: PWM input signal to set the pump speed. The PWM signal
characteristics must be the following:
TV 1001 SEM User Manual / 87-900-973-01 (H)
Signal characteristics and use
SIGNAL NAME
START/STOP (+)
START/STOP (-)
INTERLOCK (+)
INTERLOCK (-)
SPEED SETTING (+)
SPEED SETTING (-)
SOFT START (+)
SOFT START (-)
+24 Vdc
SPARE
PROGRAMMABLE SET POINT
SPARE
FAULT OUTPUT
PROGRAMMABLE ANALOG SIGNAL (+)
GROUND

PROGRAMMABLE ANALOG SIGNAL (-)

Technical Information
Interconnections
IN-/OUTPUT
IN
IN
IN
IN
IN
IN
IN
IN
OUT
OUT
OUT
OUT
OUT
253/296
17