Serial Cable Installation; Tv 1001 Sem Controller Installation - Agilent Technologies TV 1001 SEM Notice De Mode D'emploi

Serial Cable Installation

The supplied serial cable must be installed when the TV 1001 SEM or the
optional vent valve have to be controlled by means of a remote computer.
The cable is installed fixing the 9 pin D-type connector into the P2 serial
connector as shown in the following figure.
Figure 42

TV 1001 SEM Controller Installation

The controller can be mounted in two position:


To install the controller execute the following procedures.
TV 1001 SEM User Manual / 87-900-973-01 (H)
bottom mounting (as per the complete system)
side mounting.
Technical Information

Serial Cable Installation

17
281/296