Connection C - Electrical - Agilent Technologies TV 301 Mode D'emploi

17
Technical Information
TV 301Controller Installation
Connection C – Electrical
Figure 56
The turbopump is connected to the controller through an 6-pin
connector. Pins B, C and D are the 3-phase supply to the motor, pin E
is connected to the pump ground, pins A and F reserved for Agilent.
If the temperature sensor is disconnected, the pump will not start. To
prevent damage to the pump when the temperature exceeds 60 °C,
the sensor automatically cuts out the power supply.
TV 301 Navigator User Manual / 87-900-946-01 (N) 273/284