Publicité
17
Technical Information
Serial Cable Installation
Serial Cable Installation
The supplied serial cable must be installed when the TwisTorr 804 FS
Navigator or the optional vent valve have to be controlled by means
of a remote computer.
The cable is installed fixing the 9 pin D-type connector into the P2
serial connector as shown in the following figure.
Figure 56
Procedure to Connect the Serial and I/O ports to
an External Cable
In the following picture, it has showed the right procedure to connect
a cable to the I/O or to the serial port.
A shielded cable of 30 m (maximum length has to be utilized for both
serial and I/O port connection).
322/344
TwisTorr 804 FS User Manual / 87-901-052-01
Publicité
Chapitres
