Procedure To Connect The Serial And I/O Ports To An External Cable - Agilent Technologies TV 801 Navigator Bolted Flange Notice De Mode D'emploi

Procedure to Connect the Serial and I/O Ports to an
External Cable
In the following picture, it has showed the right procedure to connect
a cable to the I/O or to the serial port. A shielded cable has to be
utilized. Remove the plastic protection on both the ends of the cable
(picture b) and after it is necessary to connect the wires to the single
pins like showed in the picture c.
Take care to have a good contact between the metallic case and the external
NOTE
shield of the wire. Moreover, this operation has to be done at least on the
controller side.
In this way, you will be sure to reduce the influence of the external
noise and to accomplish the EMC requests. In picture d is showed the
cable assembled.
Figure 20
TV 801 Navigator Bolted Flange User Manual / 87-900-980-01 (D)

Procedure to Connect the Serial and I/O Ports to an External Cable

Technical Information
Picture a
Picture b
Picture d
229/248
17