Serial Cable Installation; Tv 551/701 Controller Installation - Agilent Technologies TV 551/701 Navigator Notice De Mode D'emploi

Serial Cable Installation

The supplied serial cable must be installed when the TV 551/701 Navigator or
the optional vent valve have to be controlled by means of a remote computer.
The cable is installed fixing the 9 pin D-type connector into the P2 serial
connector as shown in the following figure.
Figure 52

TV 551/701 Controller Installation

The controller can be mounted in two position:


To install the controller execute the following procedures.
TV 551/701 Navigator User Manual / 87-900-934-01 (P)
bottom mounting (as per the complete system)
side mounting.
Technical Information

Serial Cable Installation

17
311/328