Publicité
Les langues disponibles
Les langues disponibles
s SWITCHING THE APPLIANCE OFF
•
Every program and every function can be interrupted at all times. To do so, you
can press the START button for 2 seconds to switch the appliance to operating
mode.
•
To switch the appliance off, press the START button for 2 seconds to switch the
appliance to operating mode and then pull the power plug to disconnect the
appliance from the power.
•
The power plug should be pulled after every use, so that the appliance is com-
pletely disconnected from the power and switched off.
O VE RHEA T P RO T E CT ION
OVE R HEA T P RO TE CT IO N
Should the appliance overheat, e.g. if there is no or too little water in the jug
Should the appliance overheat, e.g. if there is no or too little water in the jug
or if it has already evaporated, the appliance automatically switches off. In this
or if it has already evaporated, the appliance automatically switches off. In this
case, pull the plug and let the appliance cool down for approx. 30 minutes
case, pull the plug and let the appliance cool down for approx. 30 minutes
before using it again.The buttons can only be used again once the appliance
before using it again.The buttons can only be used again once the appliance
has cooled down suffi ciently. Never try to cool the appliance down by fi lling
has cooled down suffi ciently. Never try to cool the appliance down by fi lling
it with cold water! Always let the appliance cool down between two heating
it with cold water! Always let the appliance cool down between two heating
phases.
phases.
s GOOD TO KNOW
1. Never exceed the MAX marking when fi lling the jug as this might cause the
water to splash out of the jug during boiling and cause scalding resp. electric
shock!
2. Filled to the MAX marking, the jug holds 1,2 litres of water.
3. Never fi ll the jug with too little water. The MIN marking (500 ml) has to be
reached every time, otherwise the overheat protection is triggered and the
appliance switches off.
4. Always check if the lid is correctly closed before connecting the power plug to
the socket.
5. Dry the outside of the jug including the jug bottom as well as the appliance base
before plugging in the plug.
6. During a program, you can deactivate it at any time by pressing the START but-
ton for 2 seconds.
7. Should there be too little water in the jug or should the water have evaporated,
thereby triggering the overheat protection, pull the plug and let the appliance
cool down for 30 minutes before refi lling cold water into the jug.
129
Publicité
