Viewing The Bioimpedance Measurement Evaluation; Completing The Measurement Procedure; Devices With Connection To An Emr System - Seca mBCA 555 Mode D'emploi

Viewing the bioimpedance
measurement evaluation

6.7 Completing the measurement procedure

Devices with connection to an EMR
110 • seca mBCA 555/554seca mBCA 552
As soon as the measurement is completed, the Measurement compl.
message appears.
The main screen is displayed again.
8. Ask the patient to step off the weighing platform.
9. Complete the measurement procedure ➔
procedure, page
The
seca analytics 125
measuring results and evaluations ➔
NOTICE!
Incorrect measuring results
On devices that are equipped with a scanner holder, the barcode
scanner and the barcode scanner holder lie in the weighing-sensitive
area and can falsify the measuring result.
► Hang the barcode scanner in the holder.
To complete a measurement on devices that are connected to an EMR
System System, proceed as follows:
1. Make sure that the displayed measured values are plausible.
2. Scan the patient and/or user ID.
The device indicates whether the scanned IDs are correct:
User ID OK
NOTE
Whether and the point in the measurement procedure at which the
IDs have to be scanned is defined when connecting the device to your
EMR System. If you have any queries in this regard, contact your
administrator or hospital technician.
Bioimpedance measurement progress
Completing the measurement
110.
software is required to display bioimpedance
Compatible seca products, page 145.
Patient ID OK