Devices With Connection To The Seca Analytics 125 Software; Standalone Devices; Configuration - Seca mBCA 555 Mode D'emploi

Devices with connection to the
seca analytics 125 software

Standalone devices

7. CONFIGURATION

3. Press the key.
The measuring results are submitted to the EMR System and are
assigned to the electronic patient file.
Data have been submitted to the EMR System
The device is ready for the next measurement.
To complete a measurement on devices that are connected to the
software, proceed as follows:
seca analytics 125
1. Press the key.
The Date of birth dialog window appears.
2. Enter the patient's date of birth.
3. Press the key.
The measuring results are submitted to the
Data have been submitted to the EMR System
The device is ready for the next measurement.
To complete a measurement on devices that are not connected to an EMR
System or the
seca analytics 125
1. Make sure that the displayed measured values are plausible.
2. Transfer the displayed measured values to the patient file.
3. Press the key.
Measured values and manual inputs are cleared.
The device is ready for the next measurement.
NOTE
• The functions described in this part of the instructions for use are
exclusively intended for administrators and hospital technicians.
• This part of the user documentation contains information about con-
figuring the device for measuring mode and for integration into a PC
network.
• Integrating this device into a PC network containing other devices
may lead to previously unknown risks for patients, operators or third
parties. It is the responsibility of the operating company to deter-
mine, analyze, evaluate, and control these risks.
seca analytics 125
software, proceed as follows:
Configuration • 111
English
software.