Entering The Ip Address - Seca mBCA 555 Mode D'emploi

Entering the IP address

122 • seca mBCA 555/554seca mBCA 552
4. You have the following options for continuing:
► LAN: Connect the device to the network using a LAN cable
► WiFi: ➔
Connecting the device to the WiFi network
(seca connect 103), page 123
NOTICE!
Malfunction
To be able to transmit measuring results to an EMR System, an inter-
face must be set up between the
EMR System.
► Observe the system instructions for use for the
► Set up the interface in cooperation with the manufacturer of your
EMR System.
Device mode
Basic
Advanced
Expert
Service
NOTE
Manual entry is only necessary if no barcode scanner is connected to
your device. If a barcode scanner is connected, the network connec-
tion can be set up from the
1. Press the key.
The Settings menu is displayed.
2. Press the or
3. Press the Network item.
4. Press the Server address item.
5. Enter the IP address of the server on which the
software is installed:
a) Enter the value
b) Confirm your entry by pressing the
6. You have the following options for continuing:
► Connect the device to the network using a LAN cable
► Establish a WiFi connection ➔
network (seca connect 103), page 123
seca connect 103
Function available
software.
seca connect 103
key until the Network menu item is displayed.
seca connect 103
key
Connecting the device to the WiFi
software and the
seca connect 103 .
–
–
•
•