Devices With Measuring Rod: Permanently Displaying The Weight And Height (Hold); Permanently Storing Additional Weight (Pre-Tare) - Seca mBCA 555 Mode D'emploi

Devices with measuring rod:
Permanently displaying the weight
and height (Hold)
Permanently storing additional
weight (pre-tare)
104 • seca mBCA 555/554seca mBCA 552
Device mode
Basic
Advanced
Expert
Service
When the Hold function is activated, the weight and height are still displayed
after the weight has been removed from the scale. This enables you to attend
to the patient before recording the measuring results.
1. Make sure that there is no load on the scale.
2. Ask the patient to step onto the scale.
3. Wait until height measurement has been completed and, if the device is
set accordingly, the measuring results have been announced.
4. Press the Hold key.
The Hold message is displayed.
5. To deactivate the function, press the Hold key.
The symbol and the Hold message are no longer displayed.
NOTE
If the Autohold function is activated, the weight and height are auto-
matically displayed permanently as soon as stable measured values
have been achieved ➔
Device mode
Basic
Advanced
Expert
Service
The Pre-tare function can be used to permanently save an additional weight
and automatically subtract it from a measuring result, e.g. a flat-rate figure for
shoes and clothing.
Function available
Activating the Autohold function, page
Function available
–
•
•
•
113.
–
•
•
•