Avoiding Damage To The; Device; Handling The Measurement - Seca 727 Mode D'emploi Et Garantie

Avoiding damage to the

Handling the
measurement results
50 •

device

ATTENTION!
Damage to device
• Ensure that no liquids enter the device. They
can damage the electronics.
• Switch off the device before disconnecting the
power supply unit from the mains socket.
• Disconnect the power supply unit from the
mains socket if you intend to not use the
device for a longer period of time. Only this
way it can be ensured that the device is cur-
rentless.
• Make sure not to drop the device.
• Do not expose the device to any impacts or
vibrations.
• Perform function controls regularly as
described in the relevant section in this docu-
ment. Do not operate the device if it is dam-
aged or not working properly.
• Ensure that there is no heat source in the
immediate vicinity. Do not expose to direct
sunlight. The excessive temperature could
damage the electronics.
• Avoid rapid temperature fluctuations. When
the device is transported so that a tempera-
ture difference of more than 20 °C occurs, it
must stay turned off for at least 2 hours before
it can be turned on again. Otherwise, conden-
sation water will form which can damage the
electronics.
• Caustic detergents may damage the surfaces.
Only use a soft cloth dampened with mild
soapsuds to clean the surfaces of the device.
• Only use disinfectants suitable for sensitive
surfaces. Suitable disinfectants are available
from specialist dealers.
WARNING!
Patient hazard
This device is no diagnostic device. It simply
assists the treating physician in establishing a
diagnosis.
– In order to make a precise diagnosis and
initiate therapeutic measures, besides
determination of the weight, further targeted