Cleaning - Maxx Z 09763 Mode D'emploi

Cleaning

ATTENTION!
■ Burn hazard! Allow the device to cool off completely before you clean it.
■ Danger of electrocution! Prior to each cleaning, pull the mains plug out of the sock-
et.
■ Danger of electrocution! Keep the motor unit, mains cord and plug away from water
or other liquids! Never touch them with wet hands. The motor unit is not suitable for
cleaning in the dishwasher.
■ Risk of injury associated with sharp blades! Be very careful when handling the
cross-blade adapter. The cutting blades are extremely sharp. Never touch the blades
with your bare hands. Always hold the cross-blade adapter fi rmly by the top end or
shaft when removing, inserting or cleaning it. Remove it before you clean the mixing
bowl!
■ Risk of damage to the device! Do not submerge the mixing bowl in water or other
liquids. No liquid may penetrate the bottom part of the mixing bowl as heating ele-
ments and other electronic components are installed there. Therefore, also do not
clean it in the dishwasher. Briefl y rinse it off under running water.
■ Risk of damage to the cross-blade adapter! Do not leave the cross-blade adapter
in water or other liquids for more than 2 hours to prevent damage. It is not suitable for
cleaning in the dishwasher.
■ The surfaces could be damaged! Do not use any scouring or abrasive cleaners or
scouring sponges to clean the device. They could damage the surface.
If the mixing bowl and cross-blade adapter are only slightly dirty, it is suffi cient to
clean them by briefl y mixing them with water. For this, add 1 litre of water and a
few drops of detergent to the mixing bowl. Close it, select speed level 4 or 5 and
push the TURBO button a few times. Then rinse the mixing bowl out thoroughly
with clean water.
• Immediately clean the mixing bowl and accessories after use to prevent the formation
of germs:
1. Ensure that the product is disconnected from the mains supply!
2. After emptying the mixing bowl, rinse it briefl y under running water.
3. Remove the cross-blade adapter. For this, follow the instructions in the chapter "Us-
ing the accessories properly", section "Cross-blade adapter".
4. Thoroughly rinse the mixing bowl and cross-blade adapter under running water. You
can use a mild detergent. If necessary, remove the sealing ring from the cross-blade
adapter.
5. If necessary, wipe the motor unit off with a damp cloth. Dry it off with a soft cloth.
6. You can clean the other accessories in the dishwasher. Clean the sealing rings for the
lid and steamer adapter separately.
7. Let all parts dry completely before reassembling them. Put all sealing rings back in.
8. Store the device in a clean, dry area that is not accessible to children and animals.
NOTE: The plastic parts may discolour with time. However, this is of no concern with
respect to health or the functioning of the device parts.
51 EN