Maxx Z 09763 Mode D'emploi page 47

1. Place the motor unit on a work surface:
– It must be dry, clean, level and not heatable.
– Make sure that there is enough distance to the edge of the work surface so that the
device does not fall down when in operation; also make sure that there is adequate
distance to other heat sources such as stovetops.
– There should also be clearance over the device (to cupboards and cabinets) and
on the sides in order to prevent any damage from any hot steam that is emitted.
– Also select a place where you can conveniently operate the device.
2. Make sure that the suction feet properly stick to the work surface.
3. Insert the mains plug in a properly installed socket that is easily accessible.
4. Make sure that the cross-blade adapter is properly fi xed in the mixing bowl. If you
would like to use additional accessories, e.g. for stirring or steaming, follow the in-
structions in the chapter "Using the accessories properly".
5. Add the ingredients to the mixing bowl as desired. Do not exceed the MAX mark in
the mixing bowl!
6. Secure the lid on the mixing bowl and insert it in the motor unit. If you do not want to
cook or steam, close the opening in the lid with the enclosed measuring cup.
9. To heat up or cook the ingredients, push the TEMP button and select a temperature
between 30 °C and 120 °C with the rotary knob. NOTE: The temperature can only be
set with a preselected cooking time (see above).
10. To activate and deactivate the cross-blade adapter, push the SPEED button and then
select a low speed with the rotary knob. During operation, slowly increase the speed
to the desired level. NOTE: Once the contents of the mixing bowl have reached a
temperature of 60 °C with the heating function on, the maximum speed level is 4.
11. Push the button and the device will start working.
• The preselected cooking time, temperature and speed level can be changed
at any time while preparing food. For this, push the corresponding button and
change the setting with the rotary knob.
• You can add ingredients through the opening in the lid while cooking.
• Push the
er settings will then remain in effect until the
Sleep mode has activated, push the
12. Once the set cooking time has elapsed, the device will stop automatically and all indi-
cators on the display will be set to 0. Repeat steps 8 to 11 if you would like to continue
processing the ingredients.
13. Switch the device off (fl ip the On/Off switch to position 0) and pull the mains plug out
of the socket.
14. Carefully take the mixing bowl out of the motor unit, open it and remove the food you
are mixing or cooking.
47
7. Turn on the motor unit by fl ipping the On/Off switch on the
bottom of the motor unit to position I.
8. Set the cooking time (max. 60 minutes): By pushing the
TIME button, you switch between the minute and second
setting. After pushing the TIME button, select the cooking
time with the rotary knob.
NOTE: You can skip this step if you just want to chop up
the ingredients or mix them and not heat them. However,
do not leave the device unattended in the process!
button to interrupt the cooking process. The timer and the oth-
button is pushed again. If
button twice.
EN