Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
‼ NOTE
•
Do not over tighten any component with
pivoting function.
•
Make sure all pivoting components are able
to move freely.
Weight plate installation
Deep Groove
Cable Tension Adjustment
Do not tighten all Nuts
and Bolts in this step.
Slide weight plates
onto Guide Rod from
top to bottom.
The deep groove on
each weight plate
needs to face front and
downwards.
Adjust the tension of
the Cable System by
moving the position of
lower Pulley on the two
Double Floating Pulley
Brackets.
If the tension is too
loose, move the lower
pulley up by one hole.
If the tension is too
tight, move the lower
pulley down by one
hole
Operation notes
Weight Plate Selection
- Use the Weight Selector Pin to select the
number of weight plates to exercise.
- Do not insert weight selector pin while the
weight stack or top plate is in elevated position.
- Be certain the weight Selector Pin is completely
inserted.
- Each Weight Plate weights approximately 5kgs.
- Please refer to Weight Resistance Chart page.
- Never use dumbbells or other means to
increase the weight resistance. Use only weight
plates provided by manufacturer.
- For safety purpose while the equipment is
not in use. Insert the Lock Pin into the hole on
Guide Rod, to prevent the movement of Weight
Plates.
Weight resistance chart
1
14
6
2
20
9
3
26
11
4
32
14
5
38
16
6
43
18
7
49
20
8
55
22
9
61
25
10
67
27
11
73
29
12
79
31
‼ NOTE
•
Each plate weights 5 kgs.
•
Numbers are approximate.
•
Actual weights may vary.
•
Values for Butterfly are for each arm.
Values are shown in kgs
English
13
14
18
20
22
26
27
32
32
38
36
43
41
49
45
55
50
61
54
67
59
73
63
79
15
Publicité
Chapitres
Table des Matières
