Preoperative Setup; Vacuum Hose Connection; Power Up; Cleaning The Vacuum Head - KCI CelluTome Système de prélèvement de cellules épidermiques Manuel D'utilisation

PREOPERATIVE SETUP

VACUUM HOSE CONNECTION

1. Locate the tubing connections inside the cradle of the control unit.
2. Plug the vacuum head's heater tube (A) and the vacuum tube (B) into the control unit connections as
shown below.
Vacuum Head Tubing

POWER UP

1. Plug control unit into a power outlet.
2. Press On / Off switch on the outside of the control unit's lower back panel. The Status Indicator light
will be amber.
3. Press the Power button on the user interface panel to turn the control unit on. The Status Indicator
light will change from amber to green.
Control Unit
Control Unit (Back)
Power Cord
Connection
To isolate the control unit from supply mains, unplug the AC
power from the wall outlet.
Position the unit so that the power cord connection is accessible
at all times to allow for immediate disconnection from power
source, if necessary.
On / Off
Switch
13