Malaguti Madison3 125ie Manuel D'utilisation Et D'entretien page 159

5.16 BATTERY (12V - 12Ah maintenance free)
The battery is under the passenger's seat.
Fitting battery (operation performed delivery)
To fit battery, proceed as follows:
• Take a charged battery.
• Apply the adhesive band supplied with the vehicle as shown in
Fig. 44, removing the two protective films from the ends of the
adhesive area, as shown by the arrow in the drawing (P - Fig. 44).
• Raise the seat with the ignition key.
• Loosen the two screws (V - Fig. 45) securing the passenger's
seat in place using an Allen wrench.
• Detach 30A fuse beside the battery (F - Fig. 46).
• Remove wiring with the RED/BLUE (+) and BLACK (-) wires to
connect to the battery.
• Place battery in its compartment and make sure it is correctly
seated.
• Hook the battery up.
Positive pole (+) RED/BLUE wires
Negative pole (-) BLACK wires (Fig. 46).
• Put passenger's seat back in place and secure in place with
the screws.
• Refit 30A fuse and close the door.
• (250cc version only) Perform the CONTROL UNIT SETUP
PROCEDURE (see § 5.16.1)
• Set up the instruments.
Fig. 44
5.16.1 CONTROL UNIT SETUP PROCEDURE
Every time a battery or the main fuse is connected, perform the
control unit initialisation operations, as follows:
make sure the side stand is up (idle), lights and indicators
•
are off and emergency switch is "ON"
Turn key "ON"
•
the start button).
Keep key "OFF"
•
You can now use your vehicle.
•
V
ENGLISH
(250cc version only) Should it be necessary to detach
the battery or main fuse, wait at least 30 seconds after
turning key "OFF" , to enable control unit to correctly
store information.
for at least 10 seconds (but do not press
for at least 10 seconds.
Do not use the vehicle if the battery has not been fitted
correctly and connected to its cables. This may cause
failures and short circuit of the electrical system and its
components.
-
F
+
Fig. 45
(250cc v. only)
1
.
2
3
4
5
6
Fig. 46
49