G) STAND BY:
• For changing the Main Menu display
1
2
3
:
H) Time adjustment
• This option is accessed by holding
4
5
6
18
and adjusting time.
Give the MODE button short presses to
change the Main Menu display from
Total Odometer to Revolution Counter
(RPM) and vice versa. The total dis-
tance travelled can obviously not be
reset, even when electrical power to the
vehicle is disconnected. Hold MODE
button with the vehicle at a standstill to
enable time adjustments.
If "MODE" button is not pressed for more
than 4 seconds, TOD function will auto-
matically appear.
down the MODE button within the
STAND-BY function. Each short press
of the MODE button results in a one
hour increase. To switch to minute ad-
justment, hold the MODE button down.
Minutes are adjusted in the same man-
ner.
3.12.3 ALARM FUNCTION
A) ICE ALARM:
• This means that there may be ice on
the road.
The function is activated, and an alarm
icon displayed at the centre of the dis-
play, when the sensor is recording a tem-
perature equal to or lower than 4°C. The
alarm message is maintained until the
sensor is reading a temperature of or
above 6°C.
B) OIL PRESSURE ALARM INDICATOR
(OIL bar):
• This alarm appears when the engine
is running to signal that there is a fault
involving the engine oil circuit. If the
alarm appears while using the vehi-
cle, stop the engine at once, check
the oil level and top up when the engi-
ne is cold.
If the alarm remains, have the vehicle checked immediately by
an Authorised MALAGUTI Service Centre.
Engine oil pressure sensor check (automatic)
When the ignition key is turned ON
the message "OIL bar" should appear for about 8 seconds to
signal that the engine oil pressure sensor is in working order;
the message "OIL bar" must disappear when the vehicle is
started.
ENGLISH
, before the vehicle is started,