Topping up
Before topping up, check oil level and in no case allow level to rise
above MAX notch.
Topping up to level falling between the MIN and MAX notches
means using about 200 cm
Never allow level to rise above MAX notch! This may se-
riously damage the engine, due to excessive internal
1
pressure.
2
Alarm message (low oil pressure)
The digital instrument board features a control system displaying
an "OIL BAR" message (B - § 3.12.3). The message appears
3
when the vehicle is turned on to signal that the check function is
working. The message disappears automatically after a few sec-
onds. It will only reappear during vehicle use if there is actually a
4
low oil pressure problem.
If the message appears when you are braking, when the
engine is idling or when curving, stop the vehicle, check
5
the oil level and top up if necessary. If the message re-
mains after topping up, have the vehicle checked by an
Authorised MALAGUTI Service Centre.
6
36
3
of oil (400 cm
3
for the 125cc version).
The message "OIL" is displayed on the digital instru-
ment board at the frequency reported in the MAINTE-
NANCE TABLE. This warning light indicates that it is time
to change the engine oil. This warning light is displayed
on the instrument board until the indicated operation is
carried out by an Authorised MALAGUTI Service Centre.
Waste oil is toxic for the environment, therefore we sug-
gest you contact an Authorised MALAGUTI Service Cen-
tre for disposal according to the rules in force.
ENGLISH