Malaguti Madison3 125ie Manuel D'utilisation Et D'entretien page 156

5.14.2 FRONT TURN INDICATOR
• Front turn indicator
Light bulb 12V - 15W (W15W)
Replacing front turn indicator light bulb
1
• Remove cover (C - Fig. 39) (right or left, depending on which
bulb you need to replace).
• Remove rubber lamp socket (L - Fig.39a) by turning it anti-clock-
wise.
2
• Replace light bulb.
• Refit rubber lamp socket by turning it clockwise. Fasten han-
dlebar casing.
3
The rate at which the turn indicator warning light on the
instrument board flashes will increase to signal that one
of the four indicators is not working.
C
4
5
6
Fig. 39
When performing the operations described above, pay
attention not to damage parts nearby (transmission, wir-
ing, gaskets, etc.).
46
L
Fig. 39a
5.14.3 TAIL LAMP (with stop light)
• Parking light + stop light (B - Fig. 40)
Bulb 12V - 21/5W (P21/5W)
• Rear turn indicator (E - Fig. 40)
Bulb 12V - 16W (W16W)
Visually check if the tail lamps work properly, including the stop
light and parking light, as well as turn indicators, by pulling one
of the two brake levers. If you notice improper operation, con-
tact an Authorised MALAGUTI Service Centre.
E
S
ENGLISH
Fig. 40