Aileron Servo Installation - Horizon Hobby ARF Hangar 9 Manuel D'utilisation

AILERON SERVO INSTALLATION

1. Remove the aileron servo cover from the wing.
2. Tape the string to the wing so it won't fall into the wing.
3. Use a toothpick or hobby knife to puncture the covering for the servo
cover mounting screws.
4. Use a #2 Phillips screwdriver to thread the M3 x 10 self-tapping
screws into the holes. Remove the screws before proceeding to the
next step.
 Do not press down excessively on the screw
as it could damage the structure.
5. Apply a small amount of thin CA to harden the threads made in the
previous step. Allow the CA to fully cure before installing the aileron
servo cover.
EN
6. Install the grommets and eyelets in the servos. Follow any
instructions included with the servo. Prepare both aileron servos.
7. Place a servo arm on the aileron servo to help in aligning the servo
to the servo cover.
8. Fit the servo between the servo mounting tabs in the aileron servo
tray. The servo arm will be centered in the slot.
9. Mark the locations for the servo mounting screws using a pencil,
then remove the servo.
10. Use a drill and a 5/64-inch (2mm) drill bit to drill the holes for the
servo mounting screws in the locations marked in the previous step.
10