Descale; Descaling Procedure - Pando PHTV-942 Manuel D'utilisation

INOXPAN S.L.

11. DESCALE

DESCALING PROCEDURE

1. Rotate the left dial to enter the Steam
2. Rotate the right dial until the Descaling symbol
3. Press the to start the descaling function.
4. When the display shows "0,5", remove the water tank.
5. Pour 0.5 liters of an adequate descaling solution into the water tank and put the water tank back.
6. Press . The Descale cycle is initiated and takes about 30 minutes.
7. The descaling process is silent and during this process, the display shows the percentage of the
process and the descaling symbol
8. When the display shows
9. Fill the water tank with 0,5 liters of fresh water and put the water tank back.
10. Close the panel The first rinsing cycle starts.
11. When the display shows again
water tank.
12. Fill the water tank with 0.5l of cold water and put the water tank back.
13. Close the panel. The second rinsing cycle starts.
14. When the rinsing cycle has finished the display shows the symbol
water tank is removed.
15. Remove, empty and dry the water tank.
The descaling process
Sounds (produced by the water pump) that are absolutely normal can be produced.
During this process, DO NOT try to open the oven door.
menu.
.
and the oven emits a beep, remove and empty the water tank.
and the oven emits a new beep, remove and empty the
CANNOT BE STOPPED
appears on the right side of the display.
and emits a beep, until the
once started.
EN - 26