Emptying The Water Tank - Pando PHTV-942 Manuel D'utilisation

INOXPAN S.L.
8.3. REFILLING THE WATER
If, however, the water tank needs to be refilled, the Water refill message shows.
Only fill the water tank up to a maximum of 0,5l to ensure that the water does not overflow when it
is pumped back to the water tank. RISK OF OVERFLOW.

8.4. EMPTYING THE WATER TANK

When the appliance is switched off, the residual water is pumped back into the water tank.
The water in the tank may be hot. Danger of burns!
Depending on the temperature setting and length of the steam cooking functions, this can
take up to 1 hour to complete. Always wait until the
the water tank, attempting to run a second steam function or switching off the power to the
steam oven. If interrupted before finishing, the pumping will reset, which can cause the
internal water pump to run dry and make a loud vibrating noise while it runs. Over time, this
can cause damage to the pump
After the water is pumped back to the water tank, the display will show
following actions:
 Remove and empty the water tank.
 Dry the water tank and introduce it back into the slot located above the cavity. Clean and dry the
cooking space.
 Leave the appliance door open so that the cooking space can cool down and dry completely
It is advisable to remove the water tank and empty it after a cooking cycle.
This prevents the formation of bacteria and limestone inside the appliance.
If the water tank has not been removed from the oven and a new cooking cycle is started, the oven
displays the symbol.
appear on the display before removing
symbol requiring the
EN - 22