Dry Heat Sterilization Of The Mirror Sleeve; Use Of Cerec Omnicam Disposable Sleeves - Dentsply Sirona CEREC AC Notice D'utilisation

Dentsply Sirona
Operating Instructions for the Acquisition Unit
66 37 461 D 3492
D 3492.201.06.27.02 09.2017

Dry heat sterilization of the mirror sleeve

8.1.5.10
NOTICE
Dry heat sterilization and high-level disinfection must not be combined.
The process for dry heat sterilization is as follows:
1. Pre-cleaning (see „Pre-cleaning of the mirror sleeve [ → 52]")
2. Remove the mirror sleeve from the CEREC Omnicam (see
„Removing the mirror sleeve [ → 51]").
3. Sterilize the mirror sleeve using dry heat at 190°C for 6 minutes
(unwrapped) or 12 minutes (wrapped). Use only pouches which are
suitable for dry heat sterilization cycle of at least 190 ⁰ C, 12 minutes.
Alternatively, sterilize mirror sleeve using dry heat at 160°C for
120minutes or for 60minutes (unwrapped or wrapped). Use only
pouches which are suitable for dry heat sterilization cycle of at least
160 ⁰ C, 120minutes.
The CPAC Cox RAPIDHEAT Sterilizer, the CPAC Sterident Model
200 and the CPAC SteriSURE have been validated by Sirona Dental
Systems.
For 6 minutes 190°C program # 1 has to be set on the CPAC Cox
RAPIDHEAT Sterilizer.
For 12 minutes 190°C program # 3 has to be set on the CPAC Cox
RAPIDHEAT Sterilizer.
For 120 minutes 160°C the CPAC Sterident Model 200 is to be used.
For 60 minutes 160°C the CPAC SteriSURE is to be used.
4. Store the mirror sleeve in such a way that it is protected from
contamination until the next use.
5. Carefully re-attach the mirror sleeve and allow it to lock in place (see
„Refitting the mirror sleeve [ → 51]").
NOTICE
The mirror sleeve changes its color which will not have any negative
impact upon the mirror sleeve´s durability.

Use of CEREC Omnicam Disposable Sleeves

8.1.5.11
The CEREC Omnicam can use disposable plastic sleeves to ensure
maximum infection control. These are available with order number
66 32 264.
NOTICE
The disposable sleeves cannot be used with the CEREC AF and
CEREC AI systems or when using the shade detection feature or using
the Ortho software.
8 Maintenance
59