Dentsply Sirona CEREC AC Notice D'utilisation page 64

8 Maintenance
8.2 Calibrating CEREC Omnicam
62
Measuring the position of the exit window
1. Mount the bottom side of the calibration set to the tip of the camera.
"OK"
2. Click on the button.
 The calibration process is continued.
 Once the calibration is complete, a message is displayed
indicating this.
3. Confirm the message by clicking the
 The CEREC Omnicam is calibrated.
Error message during calibration
The software indicates if an error occurs during calibration. If the
calibration process resulted in errors, restart the process.
End calibration
✔
The software indicates that the calibration was completed
successfully.
"OK"
➢ Click on the button.
 The CEREC Omnicam is calibrated.
Dentsply Sirona
Operating Instructions for the Acquisition Unit
"OK"
button.
66 37 461 D 3492
D 3492.201.06.27.02 09.2017