Insert Battery (Optional) - Dentsply Sirona CEREC AC Notice D'utilisation

6 Installation and startup
6.4 Initial startup
32
Notes on network installation
The network card is installed.
The cable with the RJ-45 connectors establishes the network connection.
The network software and the driver for the network card must be
installed by your network administrator.
The acquisition unit is equipped with a WLAN card that is preconfigured
for operation with an MC XL milling unit. The integration of the acquisition
unit into the practice network with the aid of the WLAN card is not
supported by Sirona.
6.4.4

Insert battery (optional)

A Bottom door
B Storage battery
1. Open the lower door on the back panel.
NOTICE
Open with coin.
Use a coin to open the latch. Turn counterclockwise.
2. Remove the battery cover.
3. Insert the battery into the battery compartment with the mounting
screw and screw it down.
4. Plug in the battery plug.
5. Attach the battery cover.
6. Put the door back in position and lock it.
Dentsply Sirona
Operating Instructions for the Acquisition Unit
A
B
D
C Battery cover
D Battery connector
66 37 461 D 3492
D 3492.201.06.27.02 09.2017
C