Bar Code Scanner Installation Instructions - Medtronic ACT Plus Manuel De L'utilisateur

Bar Code Scanner Installation Instructions

1. Remove the 2 Phillips screws using a #2 screwdriver.
2. Install the bracket as shown in Figure 57 and secure with the 2 screws
removed in Step 1.
3. Plug the interface modular connector into the cable interface port on the
bottom of the scanner handle.
4. Connect the other end of the cable to the connector on the back of the ACT
Plus (Figure 58).
74 English
Figure 57.
Figure 58.
ACT Plus
®
Operator's Manual