Maintenance; Fuses Replacement; Cleaning; Window And Plastic Cover Cleaning - Videotec ULISSE RADICAL THERMAL Manuel D'instructions

11 Maintenance

Maintenance must be carried out by
personnel trained to operate on electrical
circuits.

11.1 Fuses replacement

Maintenance must be performed with the
power supply disconnected and the circuit-
breaker open.
If necessary, replace the fuse illustrated in figure (6.3
Connector board description, page 13).
FUSES REPLACEMENT
Voltage Fuse F1
24Vac, 50/60Hz F 6.3A H 250V 5x20
120Vac, 50/60Hz F 6.3A H 250V 5x20
230Vac, 50/60Hz F 6.3A H 250V 5x20
Tab. 12
56

12 Cleaning

12.1 Window and plastic cover
cleaning
We recommend using a soft cloth with neutral soaps
diluted with water or specific products to clean the
glasses lenses.
12.2 Cleaning the germanium
window
Fuse F2
T 8A H 250V 5x20
T 4A H 250V 5x20
T 2A H 250V 5x20
Cleaning should be done with mild soap diluted with
water.
13 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
Cleaning the window take care not to
scratch or damage the outer surface
treated with carbon coating. Damage to
this coating could also interfere with the
transparency of the surface to infrared
light.
The symbol of the crossed out bin is marked
on all products to remember this.
MNVCUPKT_1838_EN