Digital I/O Page - Videotec ULISSE RADICAL THERMAL Manuel D'instructions

8.2.10 Digital I/O Page

From menu entry Digital I/O it is possible to configure
the digital channels available in the device. What
follows is a brief description of the configurable
parameters for each digital input.
• Alarm ID: Field used to select the desired digital
input.
• Type: It indicates the default state of the digital
input.
• Action: Each input can be associated with an
action. The action is activated when the contact is
in a state other than default. The available actions
are listed below:
• NONE: No action.
• SCAN: Position the pan & tilt on the selected
preset.
• PATROL: Activate the PATROL.
• AUTOPAN: Activate AUTOPAN.
MNVCUPKT_1838_EN
• WIPER: Activate the Wiper.
• WASHER: Activate the glass cleaning sequence.
• RELAY 1: Activate Relay 1.
• RELAY 2: Activate Relay 2.
• IR FILT: Deactivate the camera's IR Filter. If
available, it turns on the LED illuminators.
To check correct operation of the alarms, a dot will
appear on the web page. The dot will be green
in normal conditions and red when an alarm is
detected.
Fig. 102
49