Roi Setup Menu - Videotec ULISSE RADICAL THERMAL Manuel D'instructions

ROI Setup: Region Of Interest (ROI) for AGC
2.
algorithm.
Plateau parameters: Provides access to the list
3.
of parameters configurable for Plateau mode.
Linear parameters: Provides access to the list of
4.
parameters configurable for Linear mode.
Manual parameters: Provides access to the list
5.
of parameters configurable for Manual mode.
Auto Bright parameters: Provides access to the
6.
list of parameters configurable for Auto Bright
mode.
Once Bright parameters: Provides access to the
7.
list of parameters configurable for Once Bright
mode.
8. Information parameters: Provides access to the
list of parameters configurable for Information
modes.
AUTOM. GAIN CORRECTION
------------------------
1>AGC TYPE
2 ROI SETUP
3 PLATEAU PARAMETERS
4 LINEAR PARAMETERS
5 MANUAL PARAMETERS
6 PARAMETER AUTO BRIGHT>
7 PARAMETER ONCE BRIGHT>
8 PARAMETER INFORMATION>
Fig. 73
40
: PLATEAU
>
>
>
>

8.1.13.8 ROI Setup Menu

Once inside the ROI Configuration Menu it is
possible to change the region of interest (ROI) used
by the AGC algorithm to calculate the contrast and
brightness levels of the image.
Dot 1 Left: Sets the left limit of the ROI.
1.
Dot 1 High: Sets the upper limit of the ROI.
2.
Dot 2 Right: Sets the right limit of the ROI.
3.
Dot 2 Low: Sets the lower limit of the ROI.
4.
ROI SETUP
------------------------
1>POINT 1 LEFT : -460
2 POINT 1 TOP
3 POINT 2 RIGHT
4 POINT 2 BOTTOM
Fig. 74
: -460
: +460
: +460
MNVCUPKT_1838_EN