Camera Settings Page; Tools Page; Thermal Camera Menu - Videotec ULISSE RADICAL THERMAL Manuel D'instructions

8.2.11 Camera Settings page

The parameters of the IP camera that were set at
first start up can be edited in the Camera Parameters
section. In the Camera Parameters section it is
possible to specify zoom factor and precision of the
zoom position. This section also displays the data
for the different ONVIF profiles exported from the
camera.
From the Lenses menu item you can select one of the
following options:
• Motorised: P&T controlled.
• Integrated: Camera controlled.
• Fixed: Not controllable.
In the case of motorized lenses it is possible to set
up the connection (common wire or reverse polarity)
and the rotation polarity of the zoom, the Focus and
the Iris.
Fig. 103
To modify the camera settings, select the VTTunnel
button (8.2.12 Tools Page, page 50).
50

8.2.12 Tools Page

From menu entry Tools it is possible to re-set the
predefined values for the entire configuration of
device or only for a number of specific sections.
This section:
• Update the firmware of the device.
• Restart the device.
Fig. 104

8.2.13 Thermal Camera menu

Configuration of the thermal videocamera
is performed via the OSM page on the
analog version of the product. Use the
OSM ON button to launch the display (
8.2.2 User Controls page, page 45). Refer to
the relative chapter for the configuration (
8.1.13 Thermal Camera menu, page 35 50).
MNVCUPKT_1838_EN