8.2.14 Factory Default
If the password is no longer available, you
can also restore the factory settings by
pressing a Reset button situated inside the
base.
To restore the factory settings relative to the network,
user access and camera configuration follow this
procedure:
• Power the unit.
• Open the cover of the DIP-switches.
• Detect DIP switch 4 (01). Bring switch 1 down, 1
(ON) value.
• Wait for the temporary shutdownf of the LEDs (02).
• Bring switch 1 up, 0 (OFF) value.
• Close the connector housing cover.
Fig. 105
MNVCUPKT_1838_EN
01
02
9 Accessories
For further details on configuration and
use, refer to the relative manual.
9.1 Wall mount bracket
Wall bracket with internal cable channel.
Fig. 106
9.2 Parapet bracket
Parapet bracket with internal cable channel.
Fig. 107
51