Maintenance; Firmware Updating; Factory Default - Videotec MAXIMUS MVXHD Manuel D'instructions

9 Maintenance

The pre-installed camera can only be
replaced with one of the same brand and
model.
Read the product Manual A before
performing any operation.
Please provide the device serial number when
requesting any replacement parts.

9.1 Firmware updating

Firmware upgrading can be carried out
directly on the web interface.
If necessary it is possible to update the device
firmware.
For further information please contact the VIDEOTEC
service center.
MNVCMVXHDBCAM_2222_EN

9.2 Factory Default

It is possible to reset to the factory default settings.
Execute the procedure below:
• Switch off the unit.
• Connect the I/O cable grey and green wires (Tab.
5, page 6).
• Power the unit.
• Wait 30 seconds.
• Disconnect the previously connected green and
grey wires.
• Wait for 2 minutes.
• Switch off the unit.
• Power the unit.
Once the factory default procedure has
finished, you need to configure the unit as
described in chapter (6.1 Default IP address,
page 8).
9