Accessories; Instructions For Normal Operation; Special Controls; Maintenance - Videotec MAXIMUS MVXT Manuel D'instructions

7 Accessories

For further details on configuration and
use, refer to the manual of the relevant
accessory or support.
8 Instructions for normal
operation

8.1 Special controls

SPECIAL CONTROLS
Action Command
Protocol
MACRO
Reboot the Save Preset 94 Save Preset 94 Save Preset 94
device
Ini+
Enabling OSM Save Preset 95 Save Preset 95 Save Preset 95
Men+
Tab. 5
28
PANASONIC PELCO D
850
Save Preset 61 –
Save Preset 46 –

9 Maintenance

The pre-installed camera can only be
replaced with one of the same brand and
model.
Read the product Manual A before
performing any operation.
Please provide the device serial number when
requesting any replacement parts.

9.1 Firmware updating

If necessary it is possible to update the device
firmware.
The firmware update operation can be performed
remotely (MACRO and PELCO D protocols only).
For further information please contact the VIDEOTEC
service center.

9.2 Factory Default

It is possible to reset to the factory default settings.
Execute the procedure below:
• Power the unit.
• Wait for 2 minutes.
• Connect the I/O cable grey and green wires (Tab.
4, page 9).
• Wait for 2 minutes.
• Switch off the unit.
• Disconnect the previously connected grey and
green wires.
• Power the unit.
MNVCMVXTCAM_2121_EN