Configuration Via Osm; Main Menu; Language Selection Menu; Zfi Parameter Menu - Videotec ULISSE RADICAL THERMAL Manuel D'instructions

8.1.2 Configuration via OSM

The screens for the product setup are illustrated
below.

8.1.3 Main Menu

From the main menu it is possible to enter menus for
configuring the device.
This is a dynamic self-configuration menu based on
the Pan & Tilt model.

8.1.4 Language Selection Menu

The menu allows you to select the language.
LANGUAGE MENU
------------------------
1>ITALIANO
2 ENGLISH
3 FRANCAIS
4 DEUTSCH
Fig. 41
MNVCUPKT_1838_EN

8.1.5 ZFI Parameter Menu

1. Zoom: This sets the maximum zoom level that
the motorised lens can achieve.
2. Common Wire: If enabled, it manages the
motorised common wire lenses; if disabled, it
manages those with inversed polarity.
3. IR Probe: It indicates the presence of a dusk
switch to manage the Day/Night function of the
motorised lens. Three options are available:
• Off: Day/Night switching not enabled
• Internal: The dusk switch is found inside the
illuminators for Day/Night switching.
• External: The dusk switch must be connected
to the LNO terminal for Day/Night switching.
Area Titling: Allows access to the area titling
4.
submenu.
Zone Masking: This provides access to the zone
5.
masking management submenu.
Housing Serial Port: Allows access to the
6.
submenu for managing the housing serial port.
Polarity: Allows access to the submenu for
7.
managing the polarity of the Zoom, Focus and
Iris motors.
ZFI CAMERA SETTINGS
------------------------
1>ZOOM
2 COMMON WIRE
3 IR PROBE
4 ZONE TITLING
5 ZONE MASKING
6 HOUSING SERIAL PORT
7 POLARITY
Fig. 42
: 30x
: N
: EXT.
>
>
>
>
25