Maintaining And Cleaning; Maintenance And Cleaning By Users; Routine (To Be Carried Out Regularly); Cleaning The Glass - Videotec MAXIMUS MHX Manuel D'instructions

10 Maintaining and
cleaning
Before doing any technical work or
maintenance on the device, make sure that
potentially explosive atmosphere is not
present.
To reduce the risk of ignition, don't open
the device when a potentially explosive
atmosphere is present.
Before doing any technical work on the
device, disconnect the power supply.
Repair of this equipment shall be carried
out by suitably trained or supervised by
VIDEOTEC personnel in accordance with
the applicable code of practice (e.g. IEC/EN
60079-19).
10.1 Maintenance and cleaning
by users
When contacting VIDEOTEC for assistance please
provide the serial number and the identification code
of the device.
10.1.1 Routine (to be carried out
regularly)

10.1.1.1 Cleaning the glass

Water should be used, or a liquid detergent that will
not generate a hazardous situation.
MNVCMHX_1432_EN

10.1.1.2 Replacing the rear bottom gasket

In the event of gasket deterioration in the rear
bottom of the housing replace it using the gasket
supplied. In the absence of the gasket provided, only
use VIDEOTEC original spare parts.
Replace the gasket being careful to insert it correctly
into its housing.
Fig. 46

10.1.1.3 Cleaning the germanium window

When the unit is working the protection
grid must always be installed.
Remove the protective grid unscrewing the 4 screws
and washers on the front of the enclosure using a a
spark-proof tool.
Fig. 47
Use neutral soap diluted with water. Take extra care
not to scratch or damage the outer surface treated
with carbon coating. Damage to this coating could
interfere with the transparency of the surface to
infrared light. Do not use ethyl alcohol, solvents,
hydrogenated hydrocarbons, strong acids or alkalis.
Using these products will irreparably damage the
germanium surface.
Once the cleaning mount the protection grid with its
screws and washers.
35