11 Maintenance
Before carrying out any type of
maintenance, read the "Safety rules"
chapter carefully in the product manual.
CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.
When contacting VIDEOTEC for assistance please
provide the serial number and the identification
code of the model.
Use only VIDEOTEC original spare parts.
11.1 Routine maintenance
11.1.1 Inspecting the cables
The cables should not show signs of damage or
wear, which could generate hazardous situations.
In cases of damaged or worn cables, repair or
replacement will be required.
11.1.2 Replacement of the wiper blade
For further details on configuration and
use, refer to the manual of the relevant
spare part.
30
11.2 Extraordinary maintenance
11.2.1 Reset to Factory Default Settings
It is possible to reset to the factory default settings.
The effect of the Factory Default procedure is
the same as restoring the factory default settings
through the web interface (Hard Reset button).
To execute the default factory procedure, you need
to access the DIP switch (S1) on the connectors' card
(Fig. 17, page 23).
Follow the procedure below:
• Disconnect the power supply to the unit.
• Open the base of the product (6.2 Opening the
base of the product, page 20).
• Set DIP 1 of switch S1 ON.
Fig. 30
S1
MNVCEVO_2203_EN