General Information Symbols Used; Intended Use; Safety Instructions; General - Burkert 1066 Instructions De Service

G I
ENERAL NFORMATION
Symbols Used
The following symbols are used in these Operating Instructions:
marks a work step that must be carried out.
ATTENTION!
Indicates information which, if not followed, could result in danger to your health or to
the functionality of the machine.
NOTE
Indicates important additional information, tips and recommendations.

Intended use

• The control head for process valve type 1066 is used to control pneumatically-activated process
valves and record their switching statuses. Other incidents of use are deemed non-compliant.
• The Technical Data presented in these instructions, on the datasheet and on the type plate must be
checked for consistency before commissioning and complied with during operation of the control head.
• Unauthorized rebuilding or changes to the device are not allowed for safety reasons.
• Shield the control head from interventions by unauthorized persons. To this end the control head can be
secured on the boreholes present on the cover and casing by means of a lead seal and / or cutting
screw.
• The working directions given in these instructions and safety indications must be followed and
complied with at all times. If the operating instructions, safety tips, or safety information are ignored or
not followed in the proper order, the warranty shall be void.

Safety instructions

Follow the instructions of this operating manual, along with the terms of use and permitted data as
specified for process valves on the datasheets and the control head type plate, so that the device can
operate smoothly and have a long service life.
• When planning the application of the device, and during its operation, observe the general technical
rules!
• Installation and maintenance work may only be carried out by specialist staff using the correct tools!
• Use only original replacement parts for necessary repairs, and when changing these parts observe the
directions in these instructions.
• Observe the relevant accident prevention and safety regulations applicable for elekctrical equipment
while operating and maintaining the device!
• Always switch off the electrical power supply before carrying out any works on the system!
• Note that piping or valves must not be removed from a system that is under pressure!
• Take suitable measures to prevent unintentional operation or impermissible impairment.
• Following an interruption of the electrical or pneumatic supply, ensure a defined and controlled re-start
of the process!
4 - 1066