General Information; Description; Technical Data - Burkert S030 Manuel Utilisateur

The type S030 fitting has been developed with
due consideration given to accepted safety rules
and is state-of-the-art. However, risks may arise.
Failure to observe these instructions as well as any unau-
thorised work on the fitting excludes us from any liability
and also nullifies the warranty which covers the fitting and
its accessories.
4.

GeneRAl inFoRmATion

The addresses of our international branches can be found
on the last pages of this manual.
They can also be found on the Internet under:
www.burkert.com
Warranty conditions
The condition governing the legal warranty is the conforming
use of the S030 in observance of the operating conditions
specified in this manual.
information on the internet
You can find the user manual and technical data sheet
regarding the type S030 at:
www.burkert.com
english
8
Fluid • PN16 (or PN40 on request) for metal
pressure fittings
• PN 10 for plastic fittings, depends on
fluid temperature, see Fig. 1.
P [bar]
A (T ype SE30 Ex
16
15
14
13
12
11
10
9
PVDF
8
PVC+PP
7
6
5
4
PVC
3
2
1 PP
0
-30 -10 +10 +30 +50 +70 +90 +110
Fig. 1: Pressure / temperature chart of the S030 fitting
lonely
Fluid depends on the material from which the
temperature S030 fitting and the paddle-wheel are
made, see the following table.
english
10
)
Metal
PVDF
T [°C]
5.

deScRipTion

Area of application
The S030 fitting is intended to measure the flow rate of
clean fluids on DN6 to DN65 pipes thanks to its paddle
wheel. It must be combined with an electronic device (indi-
cator, on/off flow sensor or transmitter) which converts the
pulse frequency due to paddle-wheel rotation.
The electronic device can be removed without opening the
piping or stopping the process.
measuring principle
The fluid flowing in the piping makes the paddle-wheel
turn. The paddle-wheel rotational frequency f is propor-
tional to the flow rate.
6.

TechnicAl dATA

conditions of use
The fluid temperatures and pressures may be
restricted by the electronic device mounted on the
fitting: refer to the relevant manual.
Ambient depends on the device mounted on the
temperature S030. Refer to the relevant manual.
Paddle-wheel Body fitting material
material
PP • Stainless steel
• Brass
• PVDF
• PP
• PVC
PVDF • Stainless steel
• Brass
• PVDF
• PP
• PVC
english
9 9
Fluid temperature
+0°C...+80°C
+0°C...+50°C
-15°C...+100°C
+0°C...+80°C
+0°C...+50°C
english
11 11