Burkert 1066 Instructions De Service page 32

M / C
AINTENANCE LEANING
Maintenance / Cleaning
When used correctly, the Type 1066 control head works without maintenance and without problems.
Repairs may only be carried out by authorised personnel using suitable tools.
Control heads operating in facilities may become contaminated by leaking medium and other influences.
In this event the facilities must be cleaned with suitable cleaning products and finally rinsed thoroughly
with water.
ATTENTION!
Before using cleaning materials, always check the compatibility of these agents with
the materials of the housing and the cover. ON cases of soiling, or following the use of
acidic or alkaline cleaning agents, always rinse thoroughly rinse off the control head with
clear water. In doing this, pay special attention that threaded holes and depressions are
clean and drained.
30 - 1066