Installation Procedure - Burkert 1066 Instructions De Service

Installation procedure

Fix the flange adapter to the
1
process valve/Fix switching knob
to piston rod (customer-specific)
ensure that it is centred
3 Insert the control head onto
the flange adapter
Position the control head
(control head can be turned through 360°)
Secure the control head using the two
screws on the side
Remove the cover from the control
2
head
Loosen the locking screw
Turn the cover to the left to the stop
Pull the cover off upwards
4 Fit the pneumatic connections
Refer to Pneumatic Installation,
(Installation/Commissioning chapter)
I
NSTALLATION
1066 - 13