"Extraordinary" Mounting Procedure; Demounting - Corghi ARTIGLIO UNIFORMITY Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6.7. "EXTRAORdINARY" MOUNTING
PROCEdURE
- One variation of the mounting procedure explained
above may be adopted in case of rims with very
small or non-existent drop centre (fig.58a). In these
exceptional cases, the mounting procedure can be
facilitated by using a variant of the normal procedure.
- The first bead is mounted in the usual way. To mount
the second bead, position the mobile tool as during
the demounting search stage (fig.58b).
- This reduces the stresses, leaving more space for
the tyre. The remaining steps in the procedure, il-
lustrated from Fig. 54 onwards, are the same as the
standard procedure.
6.8. APPROVEd UHP ANd RUN FLAT
TYRE dEMOUNTING ANd MOUNTING PROCEdURE
For this type of tyre please refer to the instructions in the manual prepared by WDK
(German Tyre Industry Association).
6.9. NOT APPROVEd UHP ANd RUN FLAT TYRE dEMOUNTING
ANd MOUNTING PROCEdURE
N.B.: if the sensor is on the tyre valve.
dEMOUNTING PROCEdURE
• Remove the valve plunger and let all the air
out of the tyre.
• Note: If necessary, remove the valve fixing nut
and let the sensor to fall into the tyre.
• Place the sensor at 3 o'clock.
• Lower the bead breaker disc and start the
rotational bead breaking stage.
• Lubricate the bead and continue rotational
upper bead breaking until the sensor is at 12
o'clock and not beyond.
• Raise the bead breaker disc.
• Move the sensor to 6 o'clock.
• Push in the bead breaker disc and fit the
gripper at 2 o'clock.
• Apply plenty of lubricant and break the
lower bead.
150
A
Artiglio Uniformity User Manual
58a
A
58b

Publicité

Table des Matières
loading

Table des Matières