Mounting Agriculture Wheels; Demounting Tubeless And Supersingle Tyres - Corghi MONSTER AGTT Manuel D'utilisation

MOUNTING AGRICULTURE WHEELS

Tighten the pliers on the front edge of the rim and position the tool in the work position
(fig�33)� Turn the tool unit using the specific control if necessary�
Move the rear bead of the tyre beyond the pliers and the tool� Turn the wheel clockwise
(fig�34)� If necessary, move the tool near the rim to make complete mounting easier�
To make it easier to insert the inner tube (fig� 35) place the tyre on the floor�
For the front bead, position the tool near the valve with the reference mark flush with the
rim and tighten the pliers above the tool (fig�36), then turn the wheel clockwise�
N�B� For tyre mounting and demounting operations, it is a good idea to lubricate the
beads and the rim in the wheel area with grease�
NOTE
With rims with a dual well, the use of the accessory DV120 (fig�37) is recommended�
With skidder rims the use of DV120 is recommended together with the skidder terminal,
both of which are optional accessories�
DEMOUNTING TUBELESS AND
SUPERSINGLE TYRES
Break the front part of the tyre, keeping the bead pushed in the well, lubricate the shoul-
der of the rim and the bead with grease (fig�38)�
Repeat the bead breaking operation in the rear (Fig� 39)�
To demount the two beads, follow the procedures explained for agriculture wheels�
NOTE
If the rim has a 15° sloping shoulder, the bead breaking operation can be continued for
the rear bead (fig� 40) until the tyre has come completely out of the rim (only tyres up
to a width of 13")� The manufacturer has not approved this operation, however, so the
procedure should be aligned with the directives of the manufacturer, demounting the
beads one at a time� The instructions are identical to demounting agriculture wheels�
Particularly hard, Supersingle wheels can be demounted by carefully lubricating and
proceeding as for agriculture wheels�
UK
Operator's manual MONSTER AGTT 57