Multiple Operator Selector; Rapid Access To Alu S - Accu-Turn 1500 Manuel De L'opérateur

56
Operations
5.4.5 You can call up the Control Counters function at any

Multiple Operator Selector.

time, without compromising any data set. As output
If more than one operator is working simultaneously
the displays again show what was present at the
on the balancer, it is possible to use multiple wheel
moment you accessed the function.
data storage capability. Use this function to let
several operators alternate machine use and to
- Operation.
keep data saved for each. Data can be recalled at
any time by each of the operator who restarts
interrupted work, even after the unit has been
• Press the F – FINE keys simultaneously. The
switched off.
display shows "SEL ECt". Hold down until "BAL Sht"
• Press multi-user button and keep pressure on it to
appears, accompanied by an acoustic signal.
enter wheel data used at that time, the unit assigns
• Press the + or – key to obtain "Cou nt" on the display.
a user index that every user has to remember for
• Press the F key.
future data recalling in case the user intends to
• Press the + or – key to scroll through the counters,
restart his work. The operator display on the board
until you reach the one you want.
will indicate the operator identified by a letter (A, b,
C, d, E, F, G, H, I).
See the list below for interpretation of the data supplied
If preferred the multiple operator function maybe
by the counters available.
used to store "commonly" balanced wheels. If your
facility is always balancing the same size tire/wheel
1 total counter for all spins
combination, simply enter that data under one of
2 counter for spins with OK
the eight (8) operators letter. When presented with
3 counter for spins in minimization
balancing that wheel simply toggle to the assigned
4 counter for spins in service mode
operator letter parameters will be displayed so you
5 counter for spins since last calibration
can confirm that you have the right stored
parameters.
To exit the Control Counter mode, press the STOP
key twice. The displays again show the previous data
and the counterweight application LEDs highlight the
normal balancing mode (internal/external clip weights).
5.4.6

Rapid access to ALU S

The function allows you to set up the machine so
that you have faster access to the common wheel
operating modes: Standard, ALU 4, ALU 5.
The machine saves the function in the memory even
when it is switched off. To remove the function and
restore the initial condition, repeat the operations you
used to activate it:
• Power up the machine.
• When the power up stage is complete, press the
ALU button for at least three seconds, then release
it.
• Start the operation.
The Rapid Access function is ON.
Each time you press the ALU key, the unit cyclically
scrolls through the STANDARD – ALU 4 – ALU 5
modes only. In this way, operation is speeded up for
the statistically more frequent operations on the wheel.
Note: The function (ON / OFF) status is only saved
after you start an operation.
Operator's Manual ACCU 1500