The Display; Audible System Signals - Accu-Turn 1500 Manuel De L'opérateur

4.1-1
16
Layout
4.1 4.1

The display.

The display.
Refer to Figure 4.1-1. Refer to Figure 4.1-1.
Note: Note: Positions related to the internal (left) plane Positions related to the internal (left) plane
of the wheel are labeled with a number of the wheel are labeled with a number
followed by "a", while for external (right) followed by "a", while for external (right)
plane positions the number is followed by plane positions the number is followed by
"b" (e.g.: 1a, 1b). "b" (e.g.: 1a, 1b).
1. Weight Application Position (WAP) indicator.
1. As the corrective weight position on the wheel Weight Application Position (WAP) indicator.
As the corrective weight position on the wheel reaches 12:00, all weight application position (WAP)
reaches 12:00, all weight application position (WAP) indicator lights will illuminate confirming that you
indicator lights will illuminate confirming that you have located the position for weight application. All
have located the position for weight application. All weights will be applied at 12:00 with all WAP lights
weights will be applied at 12:00 with all WAP lights illuminated.
illuminated.
2. Display.
2. Depending on the stage of the program the display Display.
gives the operator information about rim sizes, Depending on the stage of the program the display
balancing weights, error codes, etc. gives the operator information about rim sizes, bal-
ancing weights, error codes, etc.
3,7 Weight position indicator.
3,7 Fit a clip-on weight at the rim position indicated
when the relative WAP indicator lights up. Weight position indicator.
Fit a clip-on weight at the rim position indicated when
4,5,6 Weight position indicator. the relative WAP indicator lights up.
Fit a stick-on weight at the rim position indicated
4,5,6 when the relative WAP indicator lights up.
Weight position indicator.
8 Fit a stick-on weight at the rim position indicated Motorcycle Dynamic and Static Indicator.
when the relative WAP indicator lights up. The indicator lights up when you activate the
motorcycle wheel balancing program or the single
8 weight (static mode).
Motorcycle Dynamic and Static Indicator.
9. The indicator lights up when you activate the mo- PAX wheel indicator.
The indicator lights when the PAX SYSTEM tyre torcycle wheel balancing program or the single
balancing programme starts. weight (static mode).
9 10. User selector display.
A numeric sequence on the display indicates which PAX wheel Indicator.
The indicator lights up when you activate the PAX user is enabled to use the balancing equipment at
SYSTEM wheel balancing mode. that moment.
11. User selector button.
User data can be stored by pressing firmly the user
button.
By pushing button, system scrolls all the users.
4.1.1

Audible System signals.

Possible beeps:
High:
the unit returns a short high beep at the start of the
balancing cycle. or after activating a key. Refer to
Chapter 4.2.
Low:
the unit returns a low beep if an error is detected,
usually together with a system message indicating
the nature of the error.
For all other audible beeps, refer to Chapter 7, as these
indicate errors.
Operator's Manual ACCU 1500